IP36-200 WATERJET INTENSIFIER PUMP

Experienced waterjet shops prefer Jet Edge hydraulic waterjet intensifier pumps.

Here’s why:

• Reliable Tie-Rod Design eliminates threads on the high pressure cylinders, end caps, and hydraulic cylinders. This reduces the likelihood of cracking and increases component life.

• Matched metal components prevent galling of hydraulic components. Intensifier designs allow for the usage of common tools instead of specialized jacking system tools. Hydraulic accumulators are standard on all pumps. This provides smoother hydraulic pressure, reduces spikes and prolongs hydraulic pump life.

• Hydraulic fluid is cooled and filtered.

• Rugged hydraulic center section incorporates high duty cycle-rated piston seal and wear rings.

• Easy Maintenance - Access panels make it easy to maintain the pump. Intensifier components can be accessed without having to get into the hydraulic center section and hydraulic rod seal.

• Leak detection block indicates seals needing replacement. (optional on some pumps).

• No special tools required.

• CE-marked attenuator smoothes pressure fluctuations and delivers constant and steady stream of UHP water.

• On-board water filtration protects pump components, maximizing machine run time.

• Standard Wye-Delta motor starter –Extends the life of the high-efficiency motor and minimizes installation costs.

• Easy Operation - Jet Edge pumps can be controlled remotely from the motion controller and have programmable dual pressures.

36,000 psi (2500 bar) Continuous Operating Pressure
200 hp, 6 gpm (22.7 lpm) Maximum Flow Rate