FineCut WMC 500II

FINECUT WMC 500II

Non-thermal precision cutting of virtually all materials
» Smallest jet size on the market
» Cuts thin structures and complex geometries
» Leading precision, excellent surface finish
» User friendly, easy to operate, easy to service
» Pioneering development

MICRO ABRASIVE WATERJET TECHNOLOGY

How small is the jet?

Whereas traditional abrasive waterjets have diameters  down to 0.38 mm, micro abrasive waterjets are even finer. Typical micro abrasive waterjets are 0.3 mm and 0.2  mm. Our ongoing development will soon result in even  smaller sizes.

Cuts through layers of different materials

The micro abrasive waterjet is effective also in combined  materials that have disparate properties, such as carbon  fibre reinforced epoxy with titanium inlays.

Narrow parallel cuts, ideal for thin sections

Even if the jet velocity is high, the force of the jet is low.  Consequently, thin sections down to 0.1 mm can be cut  without damaging the material

Fixturing solutions for complex geometry

The jet cuts omnidirectionally while the fixturing solutions  reorient the workpiece. The movement of the jet and the  workpiece is synchronized, allowing highly complex geometries and shell structrures to be created.

High tolerances and fine finish

Depending on the part material and size, tolerances can  come down to ±0.01 mm. The technology can accomplish surface roughness values below 1,6 µm (Ra). For hard  materials, roughness values can be below 0.8 µm (Ra).

Non-thermal cutting

The micro abrasive waterjet is a non-thermal cutting process and does not change the material. Surfaces produced  will be free from adverse mechanical and thermal effects.  Also no subsequent processing is required.