Built with the waterjet contractor in mind, Jet Edge's diesel-powered waterjet intensifier pumps are built for years of dependable service in harsh and remote environments.
Experienced waterjet contractors prefer Jet Edge hydraulic waterjet intensifier pumps.
Here’s why:
-
Reliable Tie-Rod Design eliminates threads on the high pressure cylinders, end caps, and hydraulic cylinders. This reduces the likelihood of cracking and increases component life.
-
Reliable Cummins turbo diesel engines - Tier 3 certified.
-
Matched metal components prevent galling of hydraulic components. Intensifier designs allow for the usage of common tools instead of specialized jacking system tools. Hydraulic accumulators are standard on all pumps. This provides smoother hydraulic pressure, reduces spikes and prolongs hydraulic pump life.
-
Hydraulic fluid is cooled and filtered.
-
Rugged hydraulic center section incorporates high duty cycle-rated piston seal and wear rings.
-
Easy Maintenance - Intensifier components can be accessed without having to get into the hydraulic center section and hydraulic rod seal.
-
Leak detection block indicates seals needing replacement. (optional on some pumps).
-
No special tools required.
-
CE-marked attenuator smoothes pressure fluctuations and delivers constant and steady stream of UHP water.
-
On-board water filtration protects pump components, maximizing machine run time.
36,000 psi (2500 bar) or 40,000 psi (2700 bar)
Continuous Operating Pressure, 80 hp
Maximum Flow Rate: 1.8 gpm (6.8 lpm) at 36,000 psi